Installing and removing RAM

The following is the procedure to install RAM modules into a UCS B-Series blade server:

1. Make sure you are wearing an ESD wrist wrap grounded to the blade server cover.
2. Undo the clips on the side of the memory slot.
3. Hold the memory module from both edges in an upright position and firmly push it straight down, matching the notch of the module to the socket.
4. Close the side clips to hold the memory module.

Memory removal is the reverse of the preceding process.

Memory modules must be inserted in pairs and split equally between each CPU if all the memory slots are not populated. Refer to the server manual for identifying memory slots pairs, slot-CPU relation, and optimized memory performance.