官术网_书友最值得收藏!

The base plate designs

The following diagram shows the robot's base plate. This plate provides provisions for two motors for the differential drive and each caster wheel on the front and back of the base plate. Motors are mentioned as M1 and M2 in the diagram and caster wheels are represented as C1 and C2. It also holds four poles to connect to the next plates. Poles are represented as P1-1, P1-2, P1-3, and P1-4. The screws are indicated as S and we will use the same screws here. There is a hole at the center to bring the wires from the motor to the top of the plate. The plate is cut on the left-hand side and the right-hand side so that the wheels can be attached to the motor. The distance from the center to the caster wheels is mentioned as 12.5 cm and the distance from the center to motors is mentioned as 5.5 cm. The center of poles is at 9 cm in length and 9 cm in height from the center. The holes of all the plates follow the same dimensions:

Design of base plate

The dimensions are not marked in the diagram; instead, they are listed in the following table:

We will discuss the motor dimensions and clamp dimensions in more detail later.

主站蜘蛛池模板: 紫金县| 清水河县| 蒙山县| 多伦县| 中卫市| 黑龙江省| 西畴县| 临夏市| 江门市| 时尚| 武冈市| 五台县| 南城县| 马龙县| 长汀县| 平江县| 镇巴县| 灵丘县| 海口市| 嵊泗县| 兴文县| 乳山市| 九龙坡区| 中西区| 靖边县| 灵丘县| 综艺| 威宁| 关岭| 改则县| 逊克县| 昆山市| 丰宁| 宜兰县| 武隆县| 莱西市| 木兰县| 从化市| 扎兰屯市| 黄大仙区| 宿松县|